Time for tires…

I ordered up a set of Avon Storms to replace the original Metzler Z6’s about a month ago, but the weather has been too poopy to get out there and get anything done.

I did get the bike out Friday and commuted to work, made a lunch run, and made it home.

I got 7857 miles out of these original tires, although you can certainly say I pushed that rear a little far. It wasn’t showing treads when I left work Friday and I almost went for a ride today. Good thing I didn’t.

Dad purchased a no-mar tire change for us since we tend to go through some tires and paying someone else to change them is getting old.

First order of business, remove the wheels from the bike. I put the FJR on the center stand then with the help of my daughter Maggie, I ‘rocked’ the center stand up on two 2×4’s to get more clearance.

DSC 7084

 

I then removed the rear tire first. Paying special attention to the ABS sensor. I found an old sock in the tool shed and put it in that to keep it covered and off of any other metal parts.

After removing the rear tire I pushed down on the bike and had her stick a 2×4 on top of the two stacked 4×4’s under the header to get the front off the ground.

DSC 7078

 

I needed to put the front ABS sensor in something and couldn’t find another sock so I used a plastic bag that I had laying around. That should work just as well.

Here are the stock Metz’s after 7857 miles.

DSC 7090

 

There’s still some life in the front, but I’m going to replace them both.

The back is SHOT… Ack!

DSC 7088

 

More fun tomorrow with the No-Mar as we figure out how to get that thing mounted to something… Dad was right we should have just bought the hitch mount thing and I may order that in the future.